Autotrol i Manual – Free download as PDF File .pdf), Text File .txt) or read online for free. Valve Exploded View. Valve Parts List. Performa Exploded View. Performa Parts List. Logix Series Controllers Parts List. TROUBLESHOOTING. SWT’s online PDF library of Autotrol Control Valve Installation, Operation, Logix Operation Manual (Models: Twin Alternating, Twin.
|Published (Last):||8 November 2018|
|PDF File Size:||1.81 Mb|
|ePub File Size:||16.84 Mb|
|Price:||Free* [*Free Regsitration Required]|
If I need one do you have a valve that can be rebilt, or how much is a new valve without the timer. I have a steady, but slow stream of water little more than a trickle coming through the drain line. I also was going to buy a rebuild kit but don’t want to waste the money if I need to replace the valve assembly.
There is no check valve anywhere inside the Autotrol With all of the flappers and other parts off one might be able aytotrol by soaking it in some thing like iron out. I will have to check one of the valves that I have in the pile, see what it sounds like. It sounds as if you need a set of new flapper valves, especially the brine pair. Yes I agree, I disassembled the valve, again, and soaked everything in a concentrated solution of Iron out and it is clean. Manyal also have an Autotrol – and the brine tank is consistently overfilling.
You don’t need any new module etc.
The time now is Thanks for all the helpful advice. After putting it back together and installing it back on the tank it still won’t siphon brine and actually water comes out of the brine well tube.
It sounds like there is leakage past the 2 and possibly the 3 flapper valves and these are the two main valves. I will let you know aytotrol results, thanks. So Kanual will get a rebuild kit and try that. I replaced all the flapper valves and everything works fine now.
I’ve cleaned the little screen and the injector – and I’ve cleaned the air auhotrol valve base. I have soaked it in Iron out, flushed it, cleaned the flapper valves, screen, injector valve basically everything that can come apart has come apart and been cleaned.
All times are Maanual While looking at the parts brake down of that valve, I see that there are some O rings between the two parts. Originally Posted by kpreilly. I’ve never seen a bad ball. Any advice would be greatly appreciated!
If the ball doesn’t seal against its seat you may get water into the salt tank. Autotrol won’t draw brine Printable View. I have an Autotrolthe problem I am having is it is not drawing brine in fact during the brine cycle it flows a small amount of water into the brine tank instead of creating the suction needed to draw brine out of the tank.
Autotrol won’t draw brine
The Autotrol part number of ATthe valve body manjal sets on top of the tank adapter module looks to be around The only “check valve” is the black rubber ball in the air check on the right side facing the control.
The air check autitrol where the brine line going to the salt tank is connected to the control valve on top the air check. I have taken the control valve off numerous times, disassembled it and cleaned it as best I can.
I remember seeing it in the manuall manuals where it showed a check valve but no real clear way to get to it. What kind of water quality are you deal with? Can you hear the valve move if you shake the valve body?
In what area is the check valve and is there anything that it can be soaked in to clean it out like Iron out. My main problem is iron, I thought about soaking it in a heavy concentrate of super iron out for a couple of days.