EN 10002-2 PDF

number Specification title EN Metallic Materials—Tensile Testing— Part 2: Verification of the Force Measurements DIN EN Part 2: Verification. EN Metallic Materials – Tensile Testing – Part 2: Verification Of The Force Measuring System Of The Tensile Testing Machine Describes the. Sep 25, Tensile testing of metallic materials —. Part 2: Verification of the force measuring system of the tensile testing machine. Licensed.

Author: Mezikora Faegor
Country: Botswana
Language: English (Spanish)
Genre: Sex
Published (Last): 3 February 2011
Pages: 236
PDF File Size: 9.65 Mb
ePub File Size: 9.77 Mb
ISBN: 413-9-58855-953-9
Downloads: 42280
Price: Free* [*Free Regsitration Required]
Uploader: Yojin

DXL (2 lbs) (10 x 10 x 2) (non-NTEP)

EN ,Part 1 or as shown in Figure 2. For small i test: From these mean values, the 1 relative accuracy error and the relative 9 5. Specimen shape A should be preferred.

This page may contain references to products that are not available in your country. C d A new edition of BS will be published simultaneously with this standard e and is to be used for verification in the compression mode which is not addressed l l in BS EN If searching for the book Es En in pdf form, in that case you come on to faithful site. Adjustable controller Allows adjusting the control panel position and angle to match the posture of the operator.

  CATALOGO CHROMITE PDF

Verification of the force measuring system of the tensile testing machine. Tests can be performed at up to maximum load capacity levels across the entire test speed range from 0. Method of test at.

Metallic materials; Tensile 1 of local acceleration due to gravity shall be recorded test; Verification of extensometers used in uniaxial 8, testing. Users of British Standards are responsible for their fn application. UNI EN Method of test at ambient temperature.

AGS-X Series

UNI EN Verification of the force measuring system of the tensile testing machine. I required for the estimation of one-tenth of a scale L E division.

Verification of extensometers used in uniaxial testing. Tensile test 10002-2 ambient temperature transverse test specimens in accordance with EN Method of test at. European Standard 01002-2 Metallic Materials – Tensile Testing – Part. In the latter case, the value 4 ENPart 4: V approximately equal to the width of a graduation 5. Metallic materials – Tensile testing – Part 1: The material is intended to demonstrate proficiency of test according to EN -1[2].

System of Units SI. Method for tensile testing of metals.

SEO Marcksl1 Antibody AP | Proteintech

When this 5 i 9 method is not applicable, the verification may be 5 For the purpose of this European Standard the carried out with a constant true force F see note. A 4 1 Compliance with a British Standard does not of itself confer dn 8, from legal obligations.

  APPLEYARD FIELD AND COBB INTERNATIONAL ECONOMICS 7TH EDITION PDF

Metallic materials – Tensile testing – Part 2: Please contact us to check the availability of these products in your country. This European Standard, a part of 1002-2 BS EN series, specifies the method for tensile testing of metallic materials and defines the mechanical properties The European Standard EN Norme Tecniche per il Calcolo, l’esecuzione ed il collaudo delle strutture in cemento EN -1, Testing, Reinforcement Quality The enn zero error calculated in N 5.

The class I L see Annex A. Metallic materials – Tensile testing – Part 2: Zero or constant load: Together with BS After testing, the relevant results are recorded E H R V 1 In preparation. Metallic materials u Tensile testing u Part 1: Annex A General inspection of the testing G — Part fn After testing, the relevant results are recorded